A simple and often-used shed design includes a pitched roof, which is a proper roof for asphalt shingles. Besides being economical, asphalt shingles are ensured for Twenty Years or more, and installing them is a task anybody can do alone. The roofing must be covered with 1/2-inch plywood sheathing, and for stability, the sheathing must be set up perpendicular to the roofing system rafters. You’ll need to determine the roofing prior to you begin so you’ll know the number of three-tab shingles to purchase. Don’t forget to purchase a package of ridge cap shingles for the peak.

Step 1

Trowel a line of roof tar onto the lower edge of the roofing deck, making use of a putty knife.

Step 2

Open a pack of three-tab shingles. Trim the tabs off of enough of them to cover the length of the roofing, using an utility knife. Location these starter strips side by side on the tar with their edges flush with the drip edge of the roofing system. Nail each one to the roof, using 2, 1-inch roof nails.

How To Put Roof Shingles On A Shed.
How To Put Roof Shingles On A Shed.

 

Step 3

Get rid of one shingle from the plan. Reduce the middle of among the tabs, utilizing an utility knife. Eliminate the cut-off part of the shingle. Set the shingle on the corner of the roof– on top of the starter strip– and drive two, 1-inch roofing nails into the back. Organize the remainder of the first row of full shingles beside that and drive two nails into each one.

Step 4

Start the next row with a complete shingle and arrange the remainder of the shingles beside it so that the tabs are offset from the ones in the row underneath. Preserve this balanced out pattern for the entire setup.

Step 5

Continue nailing shingles till you reach the peak. Bend the tabs of the last row over the peak and nail them to the other side of the roofing system. Set up shingles on the other side of the roof in the same way.

Step 6

Cover the ridge with ridge cap shingles. Bend the first one over the ridge. Nail it flush to one end of the roofing system, driving one nail near the end of the shingle on each side of the roofing. Location the next shingle on top of that a person so that it overlaps half of it and covers the nails. Attach it in the same way. Continue up until you reach the other end of the roof.

Step 7

Cut the last ridge cap in half and nail it flush with the other end of the roof. Cover the nails on that shingle with roof tar as they will not be covered by another shingle.